hardware:ad1986a
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
hardware:ad1986a [2008/06/14 16:53] – kratz00 | hardware:ad1986a [2011/02/06 11:29] (current) – kratz00 | ||
---|---|---|---|
Line 1: | Line 1: | ||
http:// | http:// | ||
- | ftp:// | + | ftp:// |
- | ftp:// | + | ftp:// |
- | ftp:// | + | ftp:// |
+ | ftp:// | ||
+ | |||
+ | Required: [[software: | ||
====Installation==== | ====Installation==== | ||
Line 17: | Line 20: | ||
| | ||
make && | make && | ||
- | make install | + | make install</ |
- | </ | + | |
If updating the driver which was installed with the Linux kernel, remove the old files before installing the new version: | If updating the driver which was installed with the Linux kernel, remove the old files before installing the new version: | ||
< | < | ||
- | rm -rf / | + | rm -rf / |
- | </ | + | |
==Alsa lib== | ==Alsa lib== | ||
Line 29: | Line 30: | ||
./configure --enable-static --disable-python && | ./configure --enable-static --disable-python && | ||
make && | make && | ||
- | make install | + | make install</ |
- | </ | + | |
==Alsa utils== | ==Alsa utils== | ||
Line 36: | Line 36: | ||
./configure && | ./configure && | ||
make && | make && | ||
- | make install | + | make install</ |
- | </ | + | |
+ | ==Alsa oss== | ||
+ | < | ||
+ | ./configure && | ||
+ | make && | ||
+ | make install</ | ||
==== Module loading ==== | ==== Module loading ==== | ||
- | < | + | < |
+ | modprobe | ||
+ | |||
+ | or to enable power saving | ||
+ | |||
+ | < | ||
+ | modprobe snd-hda-intel power_save=10 power_save_controller=Y</ | ||
==== Mixer setup ==== | ==== Mixer setup ==== |
hardware/ad1986a.1213455222.txt.gz · Last modified: 2008/06/14 16:53 by kratz00