Differences

This shows you the differences between two versions of the page.

--- hardware:ad1986a [2007/09/28 22:14] – kratz00
+++ hardware:ad1986a [2011/02/06 11:29] (current) – kratz00
@@ Line 1: / Line 1: @@
-Alsa 1.0.15rc3
+http://www.alsa-project.org/
+ftp://ftp.alsa-project.org/pub/driver/alsa-driver-1.0.24.tar.bz2\\
+ftp://ftp.alsa-project.org/pub/lib/alsa-lib-1.0.24.1.tar.bz2\\
+ftp://ftp.alsa-project.org/pub/utils/alsa-utils-1.0.24.2.tar.bz2\\
+ftp://ftp.alsa-project.org/pub/oss-lib/alsa-oss-1.0.17.tar.bz2
+Required: [[software:xmlto]] (only alsa-utils)
+====Installation====
+==Alsa driver==
-==Installation==
-Alsa driver:
 <code>
 ./configure \
-   --with-moddir=/lib/modules/`uname -r`/kernel/drivers/sound/ \
+   --with-moddir=/lib/modules/`uname -r`/kernel/sound/ \
    --with-kernel=/usr/src/linux-`uname -r` \
    --with-sequencer=yes \
    --with-oss=yes \
    --with-isapnp=no \
-   --with-cards=hda-intel &&
+   --with-cards=hda-intel,usb-audio &&
 make &&
-make install
+make install</code>
-</code>
-Alsa lib:
+If updating the driver which was installed with the Linux kernel, remove the old files before installing the new version:
+<code>
+rm -rf /lib/modules/`uname -r`/kernel/sound/*</code>
+==Alsa lib==
 <code>
 ./configure --enable-static --disable-python &&
 make &&
-make install
+make install</code>
-</code>
-Alsa utils
+==Alsa utils==
 <code>
 ./configure &&
 make &&
-make install
+make install</code>
-</code>
-== Module loading ==
+==Alsa oss==
+<code>
+./configure &&
+make &&
+make install</code>
-<code>snd-hda-intel model=laptop</code>
+==== Module loading ====
+<code>
+modprobe snd-hda-intel</code>
+or to enable power saving
+<code>
+modprobe snd-hda-intel power_save=10 power_save_controller=Y</code>
-== Mixer setup ==
+==== Mixer setup ====
 Playback controls is the default view after starting alsamixer, also available after pressing F3.