Differences

This shows you the differences between two versions of the page.

--- hardware:medion_p4410 [2008/07/23 17:15] – kratz00
+++ hardware:medion_p4410 [2010/01/13 20:39] (current) – kratz00
@@ Line 13: / Line 13: @@
 [[software:fur]], [[software:librapi2]] and [[software:synce-hal]]
-Make sure that the D-Bus Messagebus Daemon and the HAL Daemon are running.
 ===== Connecting the device =====
-Do not forget to switch on the device :)
+Make sure:
-and make sure the directory"/etc/ppp/peers/" exists.
+  * ppp_generic is loaded (if compiled as module) and ///dev/ppp// exists
+  * fuse is loaded (if compiled as module) and ///dev/fuse// exists
+  * that the D-Bus Messagebus Daemon and the HAL Daemon are running
+  * the device is switched on
+  * the directory ///etc/ppp/peers/// exists
 <code>
@@ Line 26: / Line 28: @@
 </code>
-After the device is connected and switched on dmesg output show something like this:
+After the device is connected and switched on, dmesg output should show something like this:
 <code>
 usb 3-2: new full speed USB device using uhci_hcd and address 10
@@ Line 76: / Line 78: @@
 ===== Mounting the device =====
-:!: Untested with synce 0.11.1 stuff
 <code>
@@ Line 133: / Line 133: @@
 <code>
 fusermount -u /mnt/pna
-</code>
-===== Disconnecting the device =====
-<code>
-synce-serial-abort
 </code>