Differences

This shows you the differences between two versions of the page.

--- hardware:medion_p4410 [2007/12/17 00:07] – kratz00
+++ hardware:medion_p4410 [2010/01/13 20:39] (current) – kratz00
@@ Line 1: / Line 1: @@
 ====== Faking ActiveSync on Linux ======
 Requirements:
@@ Line 13: / Line 12: @@
 </code>|
-[[software:fur]], [[software:vdccm]] and [[software:synce-serial]]
+[[software:fur]], [[software:librapi2]] and [[software:synce-hal]]
 ===== Connecting the device =====
-Do not forget to switch on the device :)
+Make sure:
-and make sure "/etc/ppp/peers/" exists.
+  * ppp_generic is loaded (if compiled as module) and ///dev/ppp// exists
+  * fuse is loaded (if compiled as module) and ///dev/fuse// exists
+  * that the D-Bus Messagebus Daemon and the HAL Daemon are running
+  * the device is switched on
+  * the directory ///etc/ppp/peers/// exists
 <code>
@@ Line 25: / Line 28: @@
 </code>
-After the device is connected and switched on dmesg output show something like this:
+After the device is connected and switched on, dmesg output should show something like this:
 <code>
 usb 3-2: new full speed USB device using uhci_hcd and address 10
@@ Line 31: / Line 34: @@
 ipaq 3-2:1.0: PocketPC PDA converter detected
 usb 3-2: PocketPC PDA converter now attached to ttyUSB0
-</code>
-<code>
-synce-serial-config ttyUSB0
-</code>
-As user:
-<code>
-vdccm
-</code>
-<code>
-synce-serial-start
 </code>
@@ Line 67: / Line 57: @@
 =========================
 Flag:          8 (Charging)
-LifePercent:   61%
+LifePercent:   52%
-LifeTime:      892
+LifeTime:      879
 FullLifeTime:  Unknown
@@ Line 80: / Line 70: @@
 Store
 =====
-Store size: 974848 bytes (0 megabytes)
+Store size: 16678912 bytes (15 megabytes)
-Free space: 760588 bytes (0 megabytes)
+Free space: 16471348 bytes (15 megabytes)
-Memory for storage: 1019904 bytes (0 megabytes)
+Memory for storage: 16777216 bytes (16 megabytes)
-Memory for RAM:     61751296 bytes (58 megabytes)
+Memory for RAM:     45993984 bytes (43 megabytes)
 </code>
@@ Line 94: / Line 84: @@
 </code>
-As user kratz00 do this to mount the filesystem on the pna:
+As user kratz00 do this, to mount the filesystem on the pna:
 <code>
 Fur /mnt/pna
 </code>
-From "cat /proc/mounts
+From "cat /proc/mounts"
 <code>
 ...
@@ Line 143: / Line 133: @@
 <code>
 fusermount -u /mnt/pna
-</code>
-===== Disconnecting the device =====
-<code>
-killall -15 vdccm
 </code>